Zenith Programming Guide - VCRs
1. Turn on your VCR.
2. Push and hold down the "Code Search" button until you see the remote control indicator light, glow. Once you see the indicator light glow, release the "Code Search" button.
3. Next, quickly Push and release the VCR button on the remote.
*note: The indicator light should flash on and off a few times before finally staying lit.
4. Locate the corresponding 3 digit VCR Codes from your Zenith Remote Codes list. Enter the first 3 digit code on the codes list by using the remote controls numbered key pad. Once the first 3 digit code on the list is entered, the indicator light should shut off.
*note: If the indicator light Does Not turn off or if it begins to flash rapidly, check your code and reenter it; or move-on to the next 3 digit code on the VCR codes list.
5. Finally, with your TV on; point the remote control at your VCR and press a few buttons button (loading a cassette tape is required to test all of the buttons). If the VCR turns off, than you have successfully programmed your remote control to operate your VCR.
*note: If the television does not turn off or if some buttons on the remote control do not operate the VCR correctly; repeat steps 1-5, but enter the next 3 digit codes on the list for your VCR brand.
6. Once the correct codes is located write it down for future use. (We recommend that you write the code on a piece of tape and stick it on the side of your VCR.)
*note: For all VCR brands but Zenith, the Record button must be pressed two times to record from you VCR. Zenith VCRs only need to be pressed one time.
Programming TVs
Programming Cable Boxes
Programming AUX
Programming with Code Search Button
