Zenith Programming Guide - AUX
*note: The AUX button allows you to program your choice of one of the following: CD or Audio Receiver, a second TV, a second VCR, or a Satellite System (such as a DirecTV receiver). Each available AUX button may be programmed for any of the above.
1. Turn on your AUX.
2. Push and hold down the "Code Search" button until you see the remote control indicator light, glow. Once you see the indicator light glow, release the "Code Search" button.
3. Next, quickly Push and release the AUX button on the remote.
*note: The indicator light should flash on and off a few times before finally staying lit.
4. Locate the corresponding 3 digit AUX Codes from your Zenith Remote Codes list. Enter the first 3 digit code on the codes list by using the remote controls numbered key pad. Once the first 3 digit code on the list is entered, the indicator light should shut off.
*note: If the indicator light Does Not turn off or if it begins to flash rapidly, check your code and reenter it; or move-on to the next 3 digit code on the AUX codes list.
5. Finally, with both your TV and AUX on; point the remote control at your AUX and press a few buttons. If the AUX turns off, than you have successfully programmed your remote control to operate your AUX.
*note: If the television does not turn off or if some buttons on the remote control do not operate the AUX correctly; repeat steps 1-5, but enter the next 3 digit codes on the list for your AUX brand.
6. Once the correct codes is located write it down for future use. (We recommend that you write the code on a piece of tape and stick it on an indiscreet location on the AUX.)
7. To program additional AUX buttons repeat steps 1-6.
Programming TVs
Programming Cable Boxes
Programming VCRs
Programming with Code Search Button
