Panasonic Sa-HT920
Here is a brief guide on how to setup your Panasonic Sa-Ht920 Remote Control. This guide can help you set up your remote control to operate the VCR tape deck or a satellite receiver.
The Panasonic Sa-HT920 can decode surround signals received through satellite broadcasts. You'll need to check out your satellite receiver's manuals for exact details. You can also find an easy to use guides right on this site. Simply find your satellite TV provider within our site map directory and follow the instructions provided.
Press [shift] + [digital] to select "D-IN" (digital in) as the source. And on the main unit press [digital in].
Panasonic Sa-HT920 Remote Codes for TVs |
Now that your device is programmed try operating it.
Operating your TV:
First, Locate and Press the [TV] button on your remote control. This action allows you to select your "TV" as the source.
Next, Direct the remote control at your television.
Try turning the TV on and off. Do this by pressing the [AV System] button.
Now try switching Between the televisions video input modes. Accomplish this action by simply pressing the [tv/video] button.
It a good idea to also check that the Channel Changing button is functioning correctly. Do this by pressing the [CH -] or the [CH +] buttons.
Lastly, try adjusting the volume button. Do this now by pressing [TV VOL -] or [TV VOL +] buttons.
If all the functions work properly then your finished and there is nothing left to do. However if some of the functions on your device did not respond. Try entering the next code on the list for that device.
-Note: You'll need to reenter the codes after you change the batteries on your remote control.
